The V2 Pro Series 3X is the greatest single user portable vaporizer on the market. Building on the popular V2 Pro Series 3 (that is very affordable), they have taken things to the next level. In this review, we’ll discuss the popular 3-in-1 vape device that is disrupting the industry in a good way. We think it’s a must own device, and you’ll see why as we go through this V2 Pro Series 3x Review.
As mentioned above, this is a 3-in-1 device, and that means that it can handle three different mediums all using the same vaporizer. It handles E-Liquid, Dry Herb, and Concentrates. It does this through independently housed smart cartridges that never allow the material to pass through the body of the device. The reason we point this fact out right away is because it allows you to take the device with you anywhere with new cartridges. If you’re planning a weedcation to Colorado, buy a new cartridge beforehand, and it can all travel with you since no residue will be in the device body like similar functioning vaporizers on the market today.
Now that we have that out there let’s dive into some of the details of the device that make it a great choice for you. If you purchase just the kit, you can get it for $84.99 with the coupon code ECR15. You can also purchase the kit with the e-liquid pods for under $94 using that same coupon code. We highly recommend you at least get the one with the pods to try them once at a discount. Then you can decide if they are right for you or not.
Inside the kit, you’ll receive one Series 3X vaporizer, one Series 3 PG Ceramic E-Liquid cartridge, one Series 3X E-Liquid Cartridge, three atomizers, and one magnetic charging cord. If you get the kit with the Pro Pods, then you’ll receive six pods of your choice of flavors and strengths. These are the equivalent of about six packs of cigarettes. To make it a 3-in-1 kit, you’ll need to buy the loose leaf cartridge for under $15 and the wax cartridge for under $25.
Once you get your V2 Pro Series 3X, you’ll want to charge the battery. It comes with a charge on it, but it is best to charge it up before using it so you get a sense of how long the battery will last. To charge the Series 3X, attach the magnetic end to the device by holding it near it, and it will snap in place. Then plug the other end into the wall and indicators will go from red to yellow to green when fully charged. Once it’s fully charged, pull it off the magnetic charging cable and drop in the cartridge you want to use. Each cartridge will connect magnetically and snap-in.
Once you drop in the cartridge, the device will automatically deter which one has been inserted and change the functioning of the device to the right settings. For e-liquid, it will function by holding the power button while drawing. You can adjust the settings of voltage and wattage by pressing the power button rapidly three times. It will then cycle through, and you can press the power button when it reaches the level you want. At this point, it is very easy to hold the button while drawing and letting go. It’s that simple. You use the different cartridges for PG and VG liquids and also can change the atomizers to find your preference. The atomizers that come with it are 0.9 Ohms (VG vaping), 1.2 Ohms (PG vaping), and 1.5 Ohms (PG vaping) and they indicate on the atomizer body the type of liquid it is for each one.
The next cartridge is the dry herb cartridge and probably the one you’re most interested in hearing about in this review. To use this cartridge, you’ll need to finely grind up the herbs going into it with a grinder. That is important for even vaping and smooth hits. This cartridge uses conduction heating that in continuous for a 2-minute cycle. You can adjust how hot it gets by following the same protocol as above in pressing the power button rapidly three times. Then it will cycle, and you can press the power button to lock it on the heat setting you want. We recommend starting with the second heat setting. After it is loaded and on the power setting you want, hold the power button until the light turns on at the bottom the device, then let go. It will be a red ring to start and progress to yellow and finally green when ready. You can begin drawing once it turns green and while it remains green without pushing any additional buttons. You’ll get 2 minutes to vape it, and then the material is most likely spent. In the case it isn’t, you can run it through another cycle. That would only happen if you pack the device too tight. You should get consistent and smooth hits the entire time. If it’s too harsh, turn the heat settings down, and that should fix the problem.
The last cartridge is the wax concentrate cartridge. You’ll unscrew the cap and place your concentrates in the cartridge up to the fill line and close it up. Then drop it in, and it’s ready to go. You can adjust the heat settings in the same fashion as the e-liquid. You should start on the lowest level and work your way up, so you don’t waste material, and it isn’t too harsh. Most people will use the lowest setting or the middle setting. As you’re aware if you’re using this cartridge, concentrates are very potent so proceed with caution as you’ll reach new highs with the use of this cartridge.
The V2 Pro Series 3 offers a lot of flexibility and is priced incredibly well compared to similar size devices. While there isn’t a comparable competitor for the 3-in-1 functionality, there are several key ones for dry herb. You’ll almost always pay as much, if not more, than the Series 3X for less features. That’s why we highly recommend this device. If you’re very price conscious, then check out the V2 Pro Series 3, but you’ll be missing some of the upgraded features. If you’re looking to share with friends, we highly recommend the V2 Pro Series 7 or V2 Pro Series 7X. They are a bigger version and offer greater capacity and power.